Copyright © 2010-2011 Kitzmiller Services. All Rights Reserved.
The rules for the construction of the valve cover racer are as follows:
No engine, propulsion or moving weights. Gravity is your friend;
The racer must be made from an internal combustion engine valve cover;
The valve cover must retain its entire original gasket-sealing surface;
The racer can have a chassis, but the chassis cannot be inter-changed with any other valve cover body after it is registered for that days race;
Nothing may extend beyond the gasket surface on the front of the racer;
There must be a total of four wheels, either inside or outside of the valve cover;
The racer must be clean (no sludge). If the racer drips oil or grease, it is disqualified;
The racer must have a permanent number affixed to the surface.
The racer dimensions are as follows:
Maximum Length 32 inches
Maximum Width 10 inches
Maximum Height 10 inches
Maximum Weight 10 pounds
Maximum Wheel Diameter 6 inches
Maximum Front Road Clearance 1-1/2 inches
The rules for the track and race are as follows:
The track will consist of two lanes with each lane 12 inches wide;
Release pin is 1-3/4 inches from track to top of pin;
Both cars will be started at the same time from the start gate;
If a racer interferes with another car, he loses that round;
If a racer is hampered by a track problem, they get another run;
The racing will be double elimination for the top eliminator trophy;
The judge's decision is final on all matters..